Two parameters describe sound insulation; Dw and Rw. Dw is the insulation between rooms. Rw is the lab-tested insulation of a wall/floor...more
Environmental Noise Levels
The max exposure time at 85 dBA is 8 hours, at 110 dBA it's just 1 min 29 seconds. If exposed, limit the time and wear hearing protection...more
Bristol - Commercial House Leakage Testing - 0117 212 0189
The office that covers this area is: Cardiff
Bristol - Commercial House Leakage Testing
At E2 Consultants we provide Commercial House Leakage Testing for Bristol. E2 Consultants' air consultants offer constructive advice on the best way to reach your target rating.
According to Part L1a, an air pressure test needs to be undertaken on 50% of all dwelling types or three units of each type depending on which value is smaller. A block of flats is considered as a separate development and should be treated as such no matter on the number of blocks on the site. Furthermore, the testing should be done on the first batch of each type of dwelling to be completed. The need to test multiple versions of each type is to confirm the design and construction procedures are up to code according to Government regulations.
The dwellings that make up the test sample are to be chosen by the Building Control Body (BCB) as well as the pressure tester. When selecting the dwellings it should be taken into account that half of the tests for each type should be scheduled during construction of the first 25% of that type. All results, including failures, should be reported back to the BCB. Undertaking the test early in the project means any adjustments can be made before the majority of construction is complete.
|Leakage Rates (m3/hr at 50Pa)|
Commercial House Leakage Testing is sometimes referred to as an Air Pressure Test, Envelope Test or an Air Permeability Test.
It is a requirement under the Building Regulations 2015 Part L that new dwellings in Bristol must pass an Commercial House Leakage Testing prior to occupation; this test certificate must be produced for the dwelling to be signed off by local Bristol building control.
The report has all the details required by the regulations to indicate that a valid test has been performed.
To carry out such a test with accurate results, we require some general requirements to be made available at the time of the test:
1. SAP Design air pressure test figure
2. Electricity supply
3. Water supply to enable traps to be filled./p>
We will seal all of the intentional leakage areas in the house prior to testing. These include: fireplaces, extractor fans, exhaust fans, trickle vents and the odd uninstalled component. Everything else will have to stay 'as is' in the property.
It's strongly suggested that if you've never had a test before, that you review our air pressure / tightness pre-test checklist below.
For a quote or for more information, call our Bristol air tightness / pressure testing consultant on 0117 212 0189 or email firstname.lastname@example.org
For further Commercial House Leakage Testing information for your area, be sure to check out Air-Testing-Bristol.co.uk.
Our other services include:
DSM / Thermal Modelling, BREEAM Credit Reports, Asbestos Surveys, Fire Risk Assessment, Acoustic Testing, Commercial EPCs, Part E / BB93, Environmental Noise, Commercial Air Testing, Display Energy Certificates, Workplace Noise, Sustainability Statements, Room Integrity Testing, SBEM Calculations (BER/TER), Thermal,
Commercial House Leakage Testing can also be known as:
Air Tightness Testing, Commercial Air Testing, Commercial Fan Pressure Testing, House Leakage Testing, Air Integrity Testing, Air Leakage Testing, Commercial Air Pressure Testing, Air Testing, Commercial Air Integrity Testing, Fan Pressure Testing, Commercial Air Tightness Testing, Commercial Air Leakage Testing, Air Pressure Testing,
Copyright 2019 E2 Specialist Consultants Limited
Company No. 06728970